Using G system Midi to switch a Hughes and kettner switchblade patch
Hi
I am attempting to use MIDI and failing miserably.
I have just bought a second hand G System to use specifically with my H&K Switchblade. I have cleared out all the user banks etc, and the firmware is the latest. I am confident my G Sysyem is clean as if just come from the factory. It’s my second G System so Ian familiar with the G System apart from Midi.
I am a newbie to MIDI so have been taking small steps, but am firmly stuck now.
So to orove the concept I have programmed 2 presets in my H&K amp, and stored them. Bank 5 patch A, and bank 5 patch B. The difference is a significant amount more gain and volume on the 5B as though I go into solo mode.
I have also set 2 user presets in the G system. 00-1 and 00-2. -1 is reverb only, and -2 is reverb land delay.
I have set the amp to Midii channel 1, Omni off. And confirmed the G system is also set to Midi 1.
Program change out is set to
Source: http://forum.tcelectronic.com